Austell, GA · Cobb County

Hardwood Floor Refinishing in Austell, GA

I'm Cristobal, and I refinish and install floors in Austell and around Cobb County. When you call, you talk to me, and I'm the one who shows up to do the work.

I can usually start within a few days. Call or text Cristobal at 404-796-7650.

Floors I work on in Austell

1980s–2000s homes. Lots of LVP and laminate replacing carpet, and refinishing on homes that already have oak.

I work all over Austell: downtown Austell, Thornton Rd, East-West Connector and Hwy 278, plus zip codes 30106, 30168.

Recent floors around Austell

Real photos from my jobs.

What I do in Austell

  • Hardwood floor refinishing: full sand to bare wood, repairs, your stain color, 3 coats of finish. Stairs and handrails too.
  • Hardwood installation: solid and engineered, site-finished or prefinished, nail-down or glue-down.
  • LVP & laminate: waterproof vinyl plank for kitchens, baths, basements and whole houses.
  • Tile: porcelain and ceramic floors, wood-look tile, showers and backsplashes.

How it works

  1. Text me photos of the floor and the rough square footage.
  2. I give you a price and come look at it in person if needed.
  3. You pick the stain. I put down samples right on your floor so you see the real color.
  4. I do the job, clean up, and you get your house back.

Common questions

How much does it cost to refinish hardwood floors in Austell?

Most refinishing jobs in Austell land around $3 to $5 per square foot depending on the stain color, repairs, and whether stairs are included. Send me photos and the square footage and I'll give you a real number.

How long does refinishing take?

A typical 500–800 sq ft job takes 3 to 4 days: one day to sand, stain the next, then coats of finish. You can walk on it in socks after about 24 hours and put furniture back after 3–4 days.

Do you work in downtown Austell and Thornton Rd?

Yes. I work all over Austell, including downtown Austell, Thornton Rd, East-West Connector, Hwy 278, and the rest of Cobb County.

Can my floors be refinished or do they need to be replaced?

Solid hardwood can usually be sanded several times. Engineered floors depend on the wear layer. If you're not sure, text me a photo of the floor and the edge of a board (at a vent or doorway) and I'll tell you.

Call 404-796-7650Text