Hardwood Floor Refinishing in Holly Springs, GA

I'm Cristobal, and I refinish and install hardwood floors in Holly Springs and the rest of Cherokee County. Holly Springs sits right between Woodstock and Canton along I-575, so I am up here often. Most of my jobs are in the subdivisions off Holly Springs Parkway, Hickory Road, Sixes Road and Toonigh Road, plus some older homes near the old downtown by the railroad. I do the sanding, the repairs and the finish myself, so the person you talk to on the phone is the person working on your floor. Call or text me at 404-796-7650 with a few photos and I'll tell you what your floors need.

The floors I see in Holly Springs

Red oak in 1990s and 2000s subdivisions. Many neighborhoods off Sixes Road and Hickory Road were built with 2ΒΌ" site-finished red oak in the foyer, dining room, kitchen and halls. After 15 to 25 years, the finish wears through where people walk, and the color turns orange. These floors usually have plenty of wood left and sand very well.

Newer homes with engineered or prefinished floors. The newer builds closer to the Parkway and the town center often have prefinished oak or engineered hardwood. Prefinished boards have a small bevel on each edge. I can sand them flat, but it takes more passes, and I check engineered floors at a floor vent first to make sure the wear layer is thick enough.

Older homes and farmhouses. A few older houses near downtown and out toward the county roads have narrow oak or heart pine, sometimes hidden under carpet. I check thickness, patch what is damaged and keep as much of the original wood as I can.

Basements, crawl spaces and Georgia humidity

A lot of Holly Springs homes are built on hills with a finished basement on one side and a crawl space on the other. That matters. Summer humidity in Cherokee County runs high, and wood floors over a damp crawl space can cup, with the board edges rising above the middle. Before I sand, I check the moisture in the boards and look under the house if I can. If the crawl space is wet, I want that fixed first. For basements on a slab, I usually recommend LVP instead of solid wood. I wrote more about that in my post on LVP vs hardwood in Georgia humidity.

How I refinish a floor

  1. I look at the floors, test the old finish and check for loose, damaged or squeaky boards.
  2. I replace or weave in new boards where pets, water or old repairs left damage.
  3. I sand to bare wood with a drum sander, then an edger along the walls, and I use a vacuum system to keep dust under control.
  4. I apply stain if you want a new color. I always do sample patches on your floor first, because red oak takes color its own way.
  5. I finish with two or three coats of water-based or oil-based polyurethane, depending on how you live and how fast you need the rooms back.

Most Holly Springs homes take three to five days from first sanding to last coat. More on the process is on my hardwood floor refinishing page.

Installation, LVP and stairs

I also install new solid and engineered hardwood, plus LVP and laminate for basements, bonus rooms and rentals. Stairs are a big part of the work here. Many two-story homes have carpeted stairs with oak treads under them, or builder-grade treads that don't match the floors. I can refinish the treads to match or replace treads and risers.

Areas I cover around Holly Springs

Sixes Road, Hickory Road, Toonigh, the Holly Springs Parkway area and old downtown Holly Springs. I also work in nearby Canton, Woodstock, Towne Lake and Cartersville.

Call or text Cristobal at 404-796-7650. Send me a few photos of your floors and I'll get back to you the same day.

Common questions

Do you work in Holly Springs often?

Yes. It is between Woodstock and Canton, so I am in this part of Cherokee County most weeks.

My floors are orange. Can you change the color?

Yes. Once the old finish is sanded off, I can stain red oak a lighter natural tone, a brown or a darker color. I do samples on your floor before you decide.

Can you sand prefinished floors with beveled edges?

Usually yes. It takes more sanding to get them flat, and I check the thickness first.

Can I stay home during the work?

Many people do. I close off the rooms I'm working in, but you will need to stay off the floor while the finish dries.

How much will it cost?

It depends on the square footage, the stain, any board repairs and the number of stairs. Text me photos and the square footage and I'll give you an exact price.

More: Hardwood floor refinishing · All service areas

Text me your project

Fill this in and it opens a text to Cristobal with your details. Photos of the floor help me give you a price faster.

On a computer? Just call or text 404-796-7650.

Call 404-796-7650Text