Hardwood Floor Refinishing in Grant Park
Grant Park has some of the oldest wood floors in Atlanta. The streets around the park, from Cherokee Avenue to Boulevard and down toward Ormewood Park, are full of Victorians and Craftsman bungalows that still have their original boards. A lot of them have been painted, carpeted, patched or sanded too many times, but most can still be brought back. I'm Cristobal, and I do the sanding, repairs and finishing myself on every job. Call or text me at 404-796-7650 with a few photos and I'll tell you what your floors need.
The floors I see in Grant Park
- Heart pine in the Victorians. Many of the older homes near the park and Oakland Cemetery have heart pine: wide, dense boards with deep orange and red tones. Heart pine is beautiful, but it is full of resin, so it clogs sandpaper fast and some stains blotch on it. I usually finish it natural or with a light tone so the grain shows.
- Narrow oak strip in the bungalows. The 1910s and 1920s bungalows usually have 1½" or 2¼" red or white oak. These floors sand well and take stain evenly, which makes them a good fit if you want a darker or more modern color.
- Patched and mixed floors. After decades of renovations, I often find a kitchen or a back addition with newer oak next to original pine, or boards replaced with a different species. I weave in matching boards where I can so the floor reads as one surface after the finish goes on.
- Thin floors from past sanding. Some floors here have been sanded three or four times. Before I start, I check the board thickness at a floor vent or threshold so I know how much wood is left to work with.
How I refinish a Grant Park floor
- Walk-through and photos. I look at the wood, gaps, loose boards, pet stains and old finishes, and I check for nails and staples left from carpet.
- Repairs first. I replace broken or rotted boards, set nails and fill gaps that need it. On old pine, I'm careful not to fill gaps that open and close with the seasons, because that filler just pops out.
- Sanding. I use a drum sander for the field, an edger along the walls and a hand scraper in corners and around old radiator spots. I work up through the grits so the surface is flat and smooth before any color goes on.
- Stain or natural. I put down test patches so you can see the color on your own wood before I commit.
- Finish coats. I apply the finish in thin, even coats with proper drying time between them, then go over the floor with you at the end.
Old houses, crawlspaces and Georgia humidity
Most Grant Park homes sit over crawlspaces, and Atlanta summers push a lot of moisture under the floor. That is why I see cupped boards in July and wide gaps in January. Before refinishing, I check moisture levels in the wood. If a floor is cupped, sanding it flat while the boards are wet can leave it crowned later, so sometimes the right move is to fix the crawlspace moisture first and wait. I also suggest running the AC or a dehumidifier during the job so the finish dries properly.
Cost
Every floor is different, so I don't post prices. The cost depends on the square footage, the type of wood, how many repairs it needs, whether you want stain, and whether there are stairs. Text me photos of your floors at 404-796-7650 and I'll give you an exact price.
Nearby areas I also cover
Besides Grant Park, I work in Ormewood Park, Summerhill, Cabbagetown and East Atlanta. See my pages for Kirkwood, Decatur and Buckhead, or read more about my hardwood floor refinishing work.
Ready to bring your Grant Park floors back? Call or text Cristobal at 404-796-7650.
Common questions
Can heart pine floors in a Grant Park Victorian be refinished?
Yes, in most cases. Heart pine is dense and holds up well. I check how thick the boards are first, then sand carefully so I don't take off more wood than needed.
My floor is painted. Can it still be saved?
Usually, yes. Paint comes off with sanding, though it takes more passes. Sometimes I find nice wood underneath that nobody has seen in years.
How long will I be out of the house?
For a typical first floor, plan on a few days from sanding to the last coat, plus drying time before furniture goes back. I give you a clear schedule before I start.
Do you fix cupped or gapped boards?
I can repair and flatten many of them, but if the cause is moisture from the crawlspace, that needs to be handled first or the problem comes back.